This fact is not lost on the ceiling box manufacturers that are producing ceiling, outlet and junction boxes that are quick to install and are made of plastics that require less and less labor to install properly. This has gotten to the point that there is now a lighting box that only needs to be pushed onto a wooden stud for it to be secured; no fasteners are needed at all. The ceiling fan manufacturers however may not be keeping pace with the trend in ceiling box installation practices. They advise the consumer of their products to reinforce or replace the existing fixture with a fan-rated ceiling box which is prudent, though are the consumers heeding their installation directives?
This led to explosive growth in the sales of fans through the home improvement retailers like Home Depot, Lowes and others. The days of showroom sales for the mid to high level fans may be in for a change due the marketing efforts of these industry giants. Marketing data suggests that approximately 70% of all ceiling fans are being installed by the homeowner within 2 years of occupying their home. They are replacing the existing lighting fixtures with higher grade fixtures and ceiling fans in the bedroom and kitchen area. The living room is also a popular choice for fixture replacement with ceiling fan and lighting kit combinations being installed in greater numbers.
The installation instructions for many of the fans available today show a metal type box that has screws going through the box and into blocking above the box. This is not what is installed in most of the newer construction homes which use the labor saving nail-on products. As a general rule builders and contractors do not provide blocking above the ceiling box with a nail-on product as the added material & labor is not cost effective. The average nail-on plastic ceiling box is rated for only supporting a 35 pound static load. They are also not fan-rated. This requires that the ceiling box be replaced with a fan-rated box before the installation of a ceiling fan. Fan-rated boxes are capable of holding 70 pound loads and are rated for this application. This is easier said than done! The nail-on products do not lend themselves to be reinforced easily since labor savings have also been applied to the construction of homes themselves. In many circumstance the average home does not have an attic, only a narrow crawl space between the trusses is provided. This combined with blow-in insulation makes the location of the ceiling box difficult if not impossible when a fan is to be hung on an upper floor.
Ceiling Friday , April 13th , 2018 - 06:33:13 AM
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does ciessummit.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.